Using a multimeter, check the resistance of the coil. You will also need to remove the inlet supply tubes. Label the location of all the wires and disconnect them. Use a bucket to catch all of the water from inside the inlet valve. Turn the water off at the source and then disconnect the supply line. The inlet valve is located at the bottom of the freezer. If you are testing the inlet valve, you must first disconnect the power so it's safe to work on your freezer. Press the switch and measure for conductivity to make sure it makes contact. Using a multimeter, you can check that the switch is working properly. If any of the terminals have corroded, you will need to replace them. Remove the inlet switch and inspect it for signs of corrosion or damage. If you see any ice forming on the fill cup, this could be because the valve is not working properly. If this isn't aligned correctly, it can cause problems with leaks. This is a funnel that directs the water into the ice cube molds. When water enters your freezer it will be put into the fill cup. Check that the pipe isn't pinched, kinked, or somewhat perforated. It's a fairly strong tube and is susceptible to damage. This is the tube that is behind your freezer. The water supply line could also be damaged or broken. After leveling, ensure that the mounting screws are tightened to prevent the ice maker from moving. Loosen the mounting screws and align the ice maker unit so that it is perfectly level. This is inside the unit and can be repositioned if needed. The ice maker unit itself can also be leveled. Then repeat the process by putting your spirit level from front to back but this time giving a slight leaning angle towards the back to give the door a natural closing movement. Continue this until the freezer is aligned properly from left to right. The leveling feet can then be adjusted by twisting them to raise and lower them. Check that the freezer is perfectly level by placing a spirit level on top of the freezer from side to side.

If it isn't level, this can cause leakage.Д«efore leveling the freezer you should unplug it so that you can work on it safely. Checking Your RefrigeratorДЇor the ice maker to work properly it needs to be perfectly level. Twist this over the wire, holding it in place.You will need to put your detective's cap on in order to inspect and diagnose what is actually causing the problem with your ice maker.

Get a twist connector from an electronics store (a small conical cap).Twist the two strands of wire together.With a wire stripper, strip about ВЅ inch (1.25cm) of insulation from each cut end.Using wire cutters, cut the wire on either side of the broken socket.

If you don't feel comfortable removing light bulb sockets, then you can just leave a light bulb in the socket or cover it with electric tape to prevent an electric shock.) Follow this method: (Note that a damaged wire or a repair using this method, unless done well, may present an electric shock or fire hazard. Removing this is not as difficult as it sounds, although each bulb you remove will cause the remaining bulbs to burn more brightly and therefore burn out sooner though removing one or two bulbs should be fine. If a new bulb still won't light up, your socket may be corroded or the wire may be damaged nearby. Mark this bulb with tape so you don't lose track, then replace this bulb as described below. Repeat until you find a bulb with current on one side of it and no current on the other.Move the tool to the middle of the problem area and test again, narrowing it down to Вј of the string.If there is no hum or light, the problem is in the half closest to the plug. If the tool hums or lights up (depending on model), the problem is in the half of the string farthest from the plug.(If your tool has a small hole for a detector, place a light bulb into the hole instead. Place the detector on this wire about halfway along the string, between two bulbs.Tug apart the braided wires to identify the one directly connected to the light bulbs.This detects the current running through the wires, so you can identify the point where it fails. If the string of lights still won't light up, move on to the detector.

How to troubleshoot ge icycle